![]() |
Boiler service Balham SW12, Tooting SW17
Boiler service Balham SW12. Providing boiler servicing services in Balham SW12, Tooting SW17, Wandsworth SW18, Tooting Bec SW17, Streatham SW16, Wimbledon SW19 and all over South West London.
Our Corgi registered & Gas Safe central heating engineers have many years experience and will service your boiler to a high standard. We service boilers for Landlords and letting agents all over South West London.
Our boiler servicing procedure
In most cases, there is a procedure to follow contained in the boiler manufacturers instruction book. Where this book is available our engineers will follow the instructions for servicing the boiler. If the book has been lost then we will use the default service procedure set out in the "Essential Gas Safety" book issued by Corgi.
Default boiler servicing procedure
Visual preliminary inspection
- Ask the client whether there are any problems with the system
- Look at the location of the boiler to determine whether it is suitable
- Inspect the boiler for damage
- Check the consumer controls and the safety devices on the boiler
- Check that the flame is burning correctly in the boiler
- Check that electrical wiring complies with electrical regulations
- Examine gas supply pipework for correct installation
- Make sure the room that houses the boiler has correct ventilation
Full boiler service procedure
- Remove the main gas burners, clean and inspect for damage
- Clean and inspect the gas injectors.
- Remove, dismantle and clean the pilot light and gas injector
- Reassemble and replace gas burners and pilot light
- Check the condition of the ignition leads and electrodes
- Clean the heat exchanger
- Refit the gas burner and check all seals
- Test gas joints for leaks
- Check appliance case and all seals
- Check the pilot flame
- Adjust flame if necessary
- Check the thermocouple
- Measure the gas pressure and flow rate
- Adjust the gas pressure and flow rate if necessary for efficient performance
- Test the flue for faults and correct operation
- Inspect the flue terminal for correct location
- If fitted, check that the system bypass valve is correctly adjusted
A proper boiler service should take around an hour. If in the course of the gas safety inspection, we find that the gas system is unsafe or needs repair we will advise you before we commence remedial work.
Contact us on 0207 837 4914 for more information on gas boiler servicing.



